MIPRO ACT-50H Handheld Transmitter - Manual (Page 3)

PROPRIETARY DESIGN TO AVOID
ACCIDENTAL POWER ON/OFF
REMOVE HANDHELD TRANSMITTER CAP:
Power OFF Transmitter.
Unscrew Lower Housing.
Pull out the cap.
INSTALL HANDHELD TRANSMITTER CAP
(Covers On/Off Switch):
Caution: We recommended the cap is fitted during
operation.
1. Unscrew lower housing in counter-clockwise
direction.
2. Insert two 1.5 Volt (AA) batteries into the
battery compartment according to the correct
polarity as shown in Figure 1. When batteries
are installed correctly, the battery meter in the
LCD screen will show the current battery
strength.
NOTE: When microphone is not in use make
sure the microphone is switched off. If
the microphone will not be used for
some time, please remove the batteries
from the battery compartment to avoid
battery leakage which could result in
damage to the microphone.
The protective handheld cap prevents accidental
power on/off and protects internal components.
BATTERY INSTALLATION
4
Power ON Transmitter.
Unscrew Lower Housing.
Pull out, reverse and
push in cap.
Fasten lower housing back in place
4
Handheld Transmitter Handheld Transmitter
3 4
(Figure 1)