Rhin-O-Tuff OD3500 - Manual (Page 2)

Setup Instructions: Diagram 5a, 5b, 5c, 5d & 5e
a)
Determine the correct size coil.
Use a coil that is at least 3/32" (2.5mm) larger than the book thickness for
coil sizes up to 3/4" (2Omm). After 3/4”, use a coil size of at least over
the book size. The larger the coil compared to the book, inserting will
become much easier.
b) Determine the correct size mandrel
There are a total of nine mandrels, which are used for coil sizes 3/16”
(5mm) up to 1-1/4" (30mm). Use the below table to choose the correct
mandrel size to coil size.
Mandrel size Inch C o i l s i z e m m
(5mm-6mm)
(7mm-8mm)
(9mm-1Omm)
(11mm-12mm)
(13mm-16mm)
(17mm-19mm)
(2Omm-23mm)
(24mm-27mm)
(28mm-30mm)
Installing the mandrel on the machine.
+ Place the mandrel (1) into the mandrel holder bracket (2) making
sure the beveled edge of the mandrel is facing the right side of the
machine. Both guide pins located on the mandrel need to line up with
both slots on the mandrel bracket. Use the black knob (3) to tighten
the mandrel in place.
+ Adjust the height of the mandrel so the center of the mandrel is the
same height as the center of the book.
d)
Adjusting the mandrel bracket
+ The mandrel assembly-adjustment knob (4) is located on the right
side of the coil inserter. Move the mandrel bracket assembly towards
the drive wheel for small mandrels and away from the drive wheel for
the larger mandrels.
+ The mandrel holder bracket-adjustment knob (5) can be adjusted to
the left or the right so the leading edge of the coil lines up with the first
hole of the book.
1/8”
3/16”
1/4”
5/16”
3/8”
1/2”
5/8”
3/4”
7/8”
1” 3/16” to 1/4”
5/16”
3/8”
7/16” to 1/2”
9/16”
3/4”
7/8”
1”
1-1/8” to 1-1/4”
Page 2
c)