Arcam CD82 - Manual (Page 5)

CD72/82
4
E
n
g
li
sh
CD72/82
5
Using your CD player
POWER 1
Press this button to switch the CD player on and off. When first
powered up with no CD installed the display shows:
--NO DISC--
LOAD 2
To install a CD, press LOAD ( or OPEN on the remote control).
The CD tray opens – it accepts 12cm and 8cm discs. Place
the CD in the tray with the label facing uppermost. Press
LOAD
again (or press PLAY , or gently push the tray in 5mm) to close
the tray. You will see the total number of tracks and total disc
time, for example…
8 52.19
TRACK INDEX MIN SEC
1 1 2 3 4 5
6 7 8
The display returns to ‘0’ after a few seconds. The disc is now
ready to play.
PLAY 3
Press to play the CD. To restart from track 1, press STOP and
then PLAY .
Make sure your amplifier’s input source selector is set to the
correct input.
STOP 4
Press to stop the CD playing. The display shows ‘0’ and the
number of tracks.
PAUSE 5
Press to pause the disc (interrupt play).
Press
PAUSE again, or PLAY to resume play from the same
point.
SEARCH 6
Press to search backwards, or to search forwards
for a particular passage within the currently playing track. If the
player is in ‘PAUSE’ mode the search is made at high speed
with the sound muted.
SKIP TRACK 7
To start a CD with a track other than the first, press or
to locate the desired track.
To select another track during play, press or
. The track
is played automatically after selection. Pressing once
returns to the start of the current track. To select the previous
track, press twice quickly. To go back two tracks, press
three times, and so on.
CDs with text
Load
You will see the total number of tracks and the total disc time
with ‘CD TEXT’ illuminated in the display. The artist and album
title scrolls across the display before returning to show the
artist and total number of tracks.
ANASTACIA
TRACK INDEX MIN SEC
CD TEXT
1 2 3 4 5
6 7 8 9 10
11 12
Play
The track number is briefly displayed, followed by the track title
scrolling across the display. The display returns to showing the
track number and time.
Track selection
When a new track is selected, the track number is briefly
displayed, followed by the track title scrolling across the
display. The display returns to showing the track number and
time.
POWER
COMPACT DISC PLAYER
TRACK PAUSE STOP PLAY LOAD
7 1 6 5 3 2 4
CD82
24 BIT DUAL MONO DACS
NOTE: The track title is always displayed when a track is
selected, either for playing or programming.
The artist is always displayed when the disc is stopped.
The
TITLE button turns the text display off.
The text display supports English only.