SMS Audio SYNC by 50 User Manual
Page 7
10
11
For Wireless Use
Connect the USB cable to charge* the headphone’s internal battery:
1
]
Connect the USB cable to charge* the 3.5mm wireless dongle:
2
]
*Both the headphones and the wireless dongle have a blue LED that will illuminate while charging;
charging time for the headphones is about 2 hours, while the dongle takes about 1.5 hours to charge.
On both the headphones and the dongle, the LED will turn off when the unit is fully charged.
Turn on the headphones using the
On / Off / Mute ( ) button
located on the left ear of the device.
3
]
• If the headphones are not yet associated with a transmitter, or if
they are searching for a transmitter, the LED will blink every second.
Turn on the 3.5mm dongle using the
On / Off ( ) switch.
4
]
• If the dongle is already associated with the headphones, the LED
will blink every 5-6 seconds on both devices.
• To perform the association (only required once), continue to step 5.
Plug the dongle into any audio source with a 3.5mm audio jack and
begin playing music. (NOTE: make sure the volume is not too high!)
5
]
Hold down the
SYNC / Bass Boost ( ) button on the left ear for 3
seconds; the blue LED will begin to blink rapidly.
6
]
Hold down the
SYNC ( ) button on the dongle for 3 seconds; again,
the blue LED will begin blinking rapidly.
7
]
• After a few seconds, you may hear a short burst of music - the
association process is not finished yet as the transmitter is searching
for other KLEER-based wireless devices.
• After about 20 seconds, the two devices are now associated with
one another and the blue LEDs will flash in unison at a slower speed.
Getting Started
Getting Started