MEGUIAR'S MV84 - Manual (Page 5)

MV84, Velocity Liquid Mold Release (XP4-57C): MV8401
__________________________________________________________________________________________
Page: 5 of 17
4.2. Most important symptoms and effects, both acute and delayed
See Section 11.1 Information on toxicological effects
4.3. Indication of any immediate medical attention and special treatment required
Not applicable
SECTION 5: Fire-fighting measures
5.1. Extinguishing media
In case of fire: Use a fire fighting agent suitable for flammable liquids and solids such as dry chemical or carbon dioxide to
extinguish.
5.2. Special hazards arising from the substance or mixture
Closed containers exposed to heat from fire may build pressure and explode.
Hazardous Decomposition or By-Products
Substance Condition
Formaldehyde During combustion.
Carbon monoxide. During combustion.
Carbon dioxide. During combustion.
Irritant vapours or gases. During combustion.
5.3. Advice for fire-fighters
Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and
prevent explosive rupture.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools. Ventilate
the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust
vapours, in accordance with good industrial hygiene practice. Warning: A motor could be an ignition source and could cause
flammable gases or vapours in the spill area to burn or explode. Refer to other sections of this SDS for information regarding
physical and health hazards, respiratory protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment. For larger spills, cover drains and build dykes to prevent entry into sewer systems or
bodies of water.
6.3. Methods and material for containment and cleaning up
Contain spill. Cover spill area with a fire-extinguishing foam. An appropriate aqueous film forming foam (AFFF) is
recommended. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent
material does not remove a physical, health, or environmental hazard. Collect as much of the spilled material as possible
using non-sparking tools. Place in a metal container approved for transportation by appropriate authorities. Clean up residue
with an appropriate solvent selected by a qualified and authorised person. Ventilate the area with fresh air. Read and follow
safety precautions on the solvent label and Safety Data Sheet. Seal the container. Dispose of collected material as soon as
possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage