MEGUIAR'S MC204 - Manual (Page 4)

MC204, Motorcycle Metal Polish (20-173B): MC20406
__________________________________________________________________________________________
Page: 4 of 11
along the ground or floor to an ignition source and flash back.
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep container tightly closed. No special storage requirements.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Aluminium oxide 1344-28-1 Health and
Safety Comm.
(UK) TWA(as inhalable dust):10
mg/m³;TWA(as respirable
dust):4 mg/m³
Naphtha (petroleum),
hydrotreated heavy 64742-48-9 Manufacturer
determined
TWA:100 ppm
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
The following eye protection(s) are recommended: Safety glasses with side shields.
Skin/hand protection
Gloves made from the following material(s) are recommended: Nitrile rubber.
Respiratory protection
None required.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Solid.
Specific Physical Form: Paste
Appearance/Odour Pleasant odour; Soft glossy ivory cream
pH Not applicable.
Boiling point/boiling range 193.3 ºC
Melting point Not applicable.