MEGUIAR'S M84 - Manual (Page 4)

M84, BSP Compound Power Cleaner (21-147A): M8401, M8432
__________________________________________________________________________________________
Page: 4 of 15
6.2. Environmental precautions
Avoid release to the environment. For larger spills, cover drains and build dykes to prevent entry into sewer systems or
bodies of water.
6.3. Methods and material for containment and cleaning up
Contain spill. Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially
available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent
material does not remove a toxic, corrosivity or flammability hazard. Collect as much of the spilled material as possible.
Place in a closed container approved for transportation by appropriate authorities. Clean up residue with detergent and water.
Seal the container. Dispose of collected material as soon as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Vapours may travel long distances along the ground or floor to an ignition source and flash back. For industrial or
professional use only. Do not use in a confined area or areas with little or no air movement. Do not handle until all safety
precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or
on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid release to the
environment. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.) Use personal protective equipment (eg.
gloves, respirators…) as required.
7.2. Conditions for safe storage including any incompatibilities
Store away from heat. Protect from sunlight. Store away from acids. Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Silica, crystalline (airborne
particles of respirable size) 1317-95-9 Health and
Safety Comm.
(UK) TWA(respirable):0.1 mg/m3
Glycerin 56-81-5 Health and
Safety Comm.
(UK) TWA(as mist):10 mg/m3
Silica, amorphous 68855-54-9 Health and
Safety Comm.
(UK)
TWA(as inhalable dust):6
mg/m3;TWA(as respirable
dust):2.4 mg/m3
1-methyl-2-pyrrolidone 872-50-4 Health and
Safety Comm.
(UK) TWA:40 mg/m3(10
ppm);STEL:80 mg/m3(20
ppm) Skin Notation
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling