MEGUIAR'S M83 - Manual (Page 5)

M83, BSP Dual Action Cleaner/Polisher (21-167A): M8301, M8332
__________________________________________________________________________________________
Page: 5 of 17
Safety Comm.
(UK)
Naphtha (petroleum),
hydrotreated heavy 64742-48-9 Manufacturer
determined
TWA:100 ppm
1-methyl-2-pyrrolidone 872-50-4 Health and
Safety Comm.
(UK) TWA:40 mg/m3(10
ppm);STEL:80 mg/m3(20
ppm) Skin Notation
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Wear eye/face protection.
The following eye protection(s) are recommended: Indirect vented goggles.
Skin/hand protection
Wear protective gloves.
Gloves made from the following material(s) are recommended: Neoprene.
Polymer laminate
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of
a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Liquid.
Appearance/Odour Sweet hydrocarbon odour; White, viscous, semi-pourable liquid
pH 7.9 - 8.9
Boiling point/boiling range 198.9 ºC
Melting point Not applicable.
Flammability (solid, gas) Not classified
Explosive properties Not classified
Oxidising properties Not classified
Flash point > 93.3 ºC [Test Method:Pensky-Martens Closed Cup]
[Details:D93-90]