MEGUIAR'S M56 - Manual (Page 6)

M56, Boat/RV Pure Liquid Wax (21-159A): M5601, M5616
__________________________________________________________________________________________
Page: 6 of 18
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Naphtha (petroleum),
hydrotreated heavy 64742-48-9 Manufacturer
determined
TWA:100 ppm
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
Biological limit values
No biological limit values exist for any of the components listed in Section 3 of this safety data sheet.
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Safety glasses with side shields.
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing.
Gloves made from the following material(s) are recommended: Nitrile rubber.
Respiratory protection
In case of inadequate ventilation wear respiratory protection. An exposure assessment may be needed to decide if a respirator
is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of
the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Liquid.
Appearance/Odour Banana fragrance; Light yellow lotion
Odour threshold No data available.
pH 7.5 - 8.5