MEGUIAR'S M45 - Manual (Page 3)

M45, Boat/RV Polish and Gloss Enhancer (original formulation): M4516
__________________________________________________________________________________________
Page: 3 of 13
Skin contact
Wash with soap and water. If signs/symptoms develop, get medical attention.
Inhalation
Remove person to fresh air. If you feel unwell, get medical attention.
If swallowed
Rinse mouth. If you feel unwell, get medical attention.
4.2. Most important symptoms and effects, both acute and delayed
See Section 11.1 Information on toxicological effects
4.3. Indication of any immediate medical attention and special treatment required
Not applicable
SECTION 5: Fire-fighting measures
5.1. Extinguishing media
In case of fire: Use a fire fighting agent suitable for flammable liquids and solids such as dry chemical or carbon dioxide.
5.2. Special hazards arising from the substance or mixture
Closed containers exposed to heat from fire may build pressure and explode.
Hazardous Decomposition or By-Products
Substance Condition
Hydrocarbons. During combustion.
Carbon monoxide. During combustion.
Carbon dioxide. During combustion.
Irritant vapours or gases. During combustion.
5.3. Advice for fire-fighters
Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and
prevent explosive rupture.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation
to disperse or exhaust vapours, in accordance with good industrial hygiene practice. Warning: A motor could be an ignition
source and could cause flammable gases or vapours in the spill area to burn or explode. Refer to other sections of this SDS
for information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment. For larger spills, cover drains and build dykes to prevent entry into sewer systems or
bodies of water.
6.3. Methods and material for containment and cleaning up
Remember, adding an absorbent material does not remove a toxic, corrosivity or flammability hazard. Contain spill.
Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially available inorganic
absorbent material. Mix in sufficient absorbent until it appears dry. Collect as much of the spilled material as possible. Place
in a closed container approved for transportation by appropriate authorities. Clean up residue with detergent and water. Seal
the container. Dispose of collected material as soon as possible.