MEGUIAR'S M18211 - Manual (Page 3)

MATERIAL SAFETY DATA SHEET G182, Ultimate Paste Wax (22-40C): 18211 09/15/10
_________________________________________________________________________________________________
Page 3 of 8
attention. Wash contaminated clothing and clean shoes before reuse.
Inhalation: Remove person to fresh air. If signs/symptoms develop, get medical attention.
If Swallowed: Do not induce vomiting unless instructed to do so by medical personnel. Give victim two glasses of water.
Never give anything by mouth to an unconscious person. Get medical attention.
SECTION 5: FIRE FIGHTING MEASURES
5.1 FLAMMABLE PROPERTIES
Autoignition temperature No Data Available
Flash Point 150 ºF [Test Method: Pensky-Martens Closed Cup]
Flammable Limits - LEL No Data Available
Flammable Limits - UEL No Data Available
5.2 EXTINGUISHING MEDIA
Use fire extinguishers with class B extinguishing agents (e.g., dry chemical, carbon dioxide).
5.3 PROTECTION OF FIRE FIGHTERS
Special Fire Fighting Procedures:
Water may not effectively extinguish fire; however, it should be used to keep fire-exposed
containers and surfaces cool and prevent explosive rupture. Wear full protective equipment (Bunker Gear) and a self-contained
breathing apparatus (SCBA).
Unusual Fire and Explosion Hazards: Combustible liquid and vapor. Closed containers exposed to heat from fire may build
pressure and explode. Vapors may travel long distances along the ground or floor to an ignition source and flash back.
Note: See STABILITY AND REACTIVITY (SECTION 10) for hazardous combustion and thermal decomposition
information.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Personal precautions
Evacuate unprotected and untrained personnel from hazard area. The spill should be cleaned up by qualified personnel. Ventilate the
area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in
accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or
vapors in the spill area to burn or explode.
Environmental procedures
For larger spills, cover drains and build dikes to prevent entry into sewer systems or bodies of water. Place in a closed container
approved for transportation by appropriate authorities. Dispose of collected material as soon as possible.
Clean-up methods
Observe precautions from other sections. Contain spill. Working from around the edges of the spill inward, cover with bentonite,
vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Collect as
much of the spilled material as possible using non-sparking tools. Clean up residue with an appropriate solvent selected by a
qualified and authorized person. Ventilate the area with fresh air. Read and follow safety precautions on the solvent label and MSDS.