MEGUIAR'S M02 - Manual (Page 4)

M02, Fine Cut Cleaner (20-19A): M0216
__________________________________________________________________________________________
Page: 4 of 14
Hazardous Decomposition or By-Products
Substance Condition
Hydrocarbons. During combustion.
Carbon monoxide. During combustion.
Carbon dioxide. During combustion.
Irritant vapours or gases. During combustion.
5.3. Advice for fire-fighters
Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and
prevent explosive rupture.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapours, in accordance with
good industrial hygiene practice. Warning: A motor could be an ignition source and could cause flammable gases or vapours
in the spill area to burn or explode.
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
Collect as much of the spilled material as possible.
6.4. Reference to other sections
Refer to Section 8 and Section 13 for more information
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapours/spray.
Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after
handling. Avoid release to the environment. Use personal protective equipment (eg. gloves, respirators…) as required.
Avoid breathing of dust created by cutting, sanding, grinding or machining. Vapours may travel long distances along the
ground or floor to an ignition source and flash back. For industrial or professional use only. Avoid contact with oxidising
agents (eg. chlorine, chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store away from acids. Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
2-Methoxyethanol 109-86-4 Health and
Safety Comm. TWA:16 mg/m3(5 ppm) Skin Notation