MEGUIAR'S G130 - Manual (Page 6)

G130, NXT Metal Polish (19-133D): G13005
__________________________________________________________________________________________
Page: 6 of 16
CEIL: Ceiling
Biological limit values
No biological limit values exist for any of the components listed in Section 3 of this safety data sheet.
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Safety glasses with side shields.
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing.
Gloves made from the following material(s) are recommended: Neoprene.
Respiratory protection
Wear respiratory protection if ventilation is inadequate to prevent overexposure. An exposure assessment may be needed to
decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program.
Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state Solid.
Specific Physical Form: Paste
Appearance/Odour Pleasant, sweet odour; Deep blue cream
Odour threshold No data available.
pH Not applicable.
Boiling point/boiling range 193.3 ºC
Melting point Not applicable.
Flammability (solid, gas) Not classified
Explosive properties Not classified
Oxidising properties Not classified
Flash point Flash point > 93 °C (200 °F)
Autoignition temperature No data available.
Flammable Limits(LEL) No data available.
Flammable Limits(UEL) No data available.
Vapour pressure No data available.
Relative density 0.89 [Ref Std:WATER=1]