MEGUIAR'S D130 User Manual

Page 4

Advertising
background image

D130, Detailer Body Solvent (DX-69A): D13001, D13005

__________________________________________________________________________________________

Page: 4 of 13

SECTION 7: Handling and storage

7.1. Precautions for safe handling
For industrial or professional use only. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Avoid
breathing dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when
using this product. Wash thoroughly after handling. Avoid contact with oxidising agents (eg. chlorine, chromic acid etc.)
Vapours may travel long distances along the ground or floor to an ignition source and flash back.

7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep cool. Keep container tightly closed. Store away from acids. Store away from
oxidising agents.

7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.

SECTION 8: Exposure controls/personal protection

8.1 Control parameters

Occupational exposure limits

Ingredient

CAS Nbr

Agency

Limit type

Additional comments

Naphtha (petroleum),
hydrotreated heavy

64742-48-9 Manufacturer

determined

TWA:100 ppm

Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling

8.2. Exposure controls

8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.

8.2.2. Personal protective equipment (PPE)

Eye/face protection

Wear eye/face protection.
The following eye protection(s) are recommended: Safety glasses with side shields.

Skin/hand protection

Gloves made from the following material(s) are recommended: Nitrile rubber.

Respiratory protection

Wear respiratory protection if ventilation is inadequate to prevent overexposure.
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with
regulations:
Half facepiece or fullface air-purifying respirator with organic vapour cartridges and P2 particulate prefilters.

Advertising