Anetsberger Brothers 14VFS - Manual (Page 8)

8
CASTER LEVELING INSTRUC-
TIONS
1. Move the fryer to its desired location.
2. Determine whether the fryer tends to wobble
or rock when in its desired location. If it
does, perform steps 3 through 9. If it does
not, skip to step 10, then proceed to the
Installation Instructions.
WARNING
The fryer MUST NOT tip, rock or wob-
ble, to avoid splashing or spilling its HOT
shortening contents during operation.
3. Determine which caster requires adjustment
and the approximate amount of change
required to level the fryer.
4. Position the side of the fryer on the ship-
ping carton, exposing the bottom of the fryer
with the caster mounting plates (Figure 5).
5. Completely unscrew the screws holding the
caster mounting plate that requires leveling
adjustment. Retain the screws for later
reassembly.
!
INSTALLATION REQUIREMENTS
(Continued)
Figure 4. Typical Caster Installation
CASTER INSTALLATION
INSTRUCTIONS
1. Flatten the shipping carton (after unpacking the
fryer and its parts and accessories) for surface
protection during caster installation.
2. Position the side of the fryer flat on the carton,
exposing the fryer bottom mounting brackets
for caster installation, as shown in Figure 4.
3. Mount locking casters on the front of the fryer
and fixed casters on the rear, by placing each
caster mounting plate flush against the mounting
bracket on the fryer bottom.
4. Insert one mounting screw through the proper
hole in the caster mounting plate and start it
into the proper hole in the fryer mounting
bracket.
5. Screw the mounting screw several turns into
the mounting bracket.
6. Repeat steps 4 and 5 until all four mounting
screws for each leg are in place.
7. Tighten the four mounting screws evenly and
securely to hold the caster mounting plate
against the fryer mounting bracket.