Team Associated RC10T4.2 - Manual (Page 13)

13
:: Shocks Build - Bag G-GG - Step 2
:: Shocks Build - Bag G-GG - Step 3
:: Shocks Build - Bag G-GG - Step 4
1777
FT shock
pivot ball
1777
Shock
eyelet
#1105
green slime
91300
12x27.5mm
shock bodies
(front)
91302
12x36mm
shock bodies
(rear)
91309
Shock hat
bushing
91309
Shock
spacer
5407
O-ring
31327
VCS3 shock
bottom cap
31327
VCS3 shock
bottom cap
o-ring
91309
12mm shock
cap o-ring
x2
x2
#1105
green slime
Racers Tip:
Lightly rub shock oil on the
o-ring before installation!
Racers Tip:
Coating the o-rings
with green slime
(#1105) helps seal
& reduce o-ring
swell! Green slime
not included in kit!
!
!
x4 91303
12mm
shock cap
Step 9-10 Step 8 Step 6-7 Step 4-5
Front Shock: 35 wt
Rear Shock: 35 wt
Step 2-3
31510
M2x4mm
bhcs
91309
Shock cap
o-ring
x4
x4 Shock Bleeding Steps:
1. Before assembly, get each bleed
screw and thread it 1-2 turns into the
shock cap. This will make installation
easier when you are bleeding your
shocks.
2. Pull shock shaft down.
3. Fill shock body 3/4 full with silicone
shock fluid.
4. Slowly move the shock shaft up and
down to remove air from under the
piston.
5. Wait for bubbles to come to surface.
6. Fill shock body to top with silicone
shock fluid.
7. Place a drop of oil in the cap and on
cap threads.
8. Install cap (without bleed screw) and
tighten completely.
9. Slowly compress shaft all the way to
bleed excess silicone shock fluid out
the hole in the cap (use rag around-
shock to catch excess fluid).
10. Install M2x4mm button head screw
until snug while shaft is fully com-
pressed.
Shock oil
#5429
Shock oil
#5429
91310
12mm shock
spring cup
(9mm offset)
91329
12mm front
spring, Gray
(3.45lb)
91336
12mm rear
spring, Green
(2.00lb)
91304
12mm
threaded
collar
91304
12mm
threaded
collar
o-ring
x4
x4
Front:
8mm
Rear:
8.5mm
Build x2 front and x2 rear shocks
Racers Tip:
Use your finger to rub
shock oil on the o-ring for
smoother adjustment!
!
!
!