Wiring diagram – Quick Cable IQ610 User Manual
Page 4
4
and the unit will start to ramp up the DC current. When the charger reaches the safe operating level the YELLOW light will start to blink.
5.
The unit will not shut off, it will maintain the voltage within it’s capabilities until the unit is turned off.
6.
If the voltage should fall below the specified level the YELLOW light will return to continuously on. If the unit can not maintain the voltage
level for more than 20 seconds then the RED light will start to flash. At this point the unit is supplying maximum output and the battery
voltage should be monitored to make sure it does not drop below minimum levels required for testing and/or programming.
WIRING DIAGRAM
MODEL IQ610 REPAIR PARTS
Item
Description
Part No.
1
Rectifier w/wiring harness............................................611194
2
Transformer .................................................................611195
3
PCB .............................................................................611155
4
Ammeter ......................................................................610346
5
Switch ..........................................................................610291
6
Switch ON-OFF-ON.....................................................611167
7
Fan Blade ....................................................................610189
8
Fan Motor w/blade.......................................................610190
9
DC Circuit Breaker (2). ................................................610987
10
AC Cord.......................................................................610696
11
DC Cable Set...............................................................610820
12
Cabinet, Front-Base-Back ...........................................611338
13
Switch momentary .......................................................610263
Parts not shown
Handle .........................................................................610057
Top Panel ....................................................................610636
Side Panel (1ea)..........................................................611214
Clamps (1 pair w/jaws) ....................................................6199
Jaw Kit (repairs 1 clamps) ...........................................610970
MAINTENANCE INSTRUCTIONS
Worn clamps should be replaced. Worn parts can lead to poor connections and present a safety hazard. See parts list for part number of D.C.
Cord kit. Any Maintenance or repair of this unit that involves disassembly of the cabinet should be done only by a qualified serviceman. Incorrect
reassembly may result in a risk of electric shock when the unit is subsequently used.