Quick Cable Quick Crimp Pneumatic Crimper - Manual (Page 3)

3
Extremely high operating pressures may
cause explosive failure and flying debris
You can crimp a variety of connectors
from 8 gauge to 4/0 using the Quick Crimp
Pneumatic Crimper
Maintaining the Quick
®
Crimp Pneumatic
The internal operating parts of the Quick Crimp
Pneumatic Crimper are factory lubricated and do
not require additional maintenance. A grease fitting
is supplied so you can grease the roller assembly
periodically. If you are using the B-crimp die set, the
guide pin should be lubricated with moly grease.
• Wear Safety Goggles.
• Do not operate without protective shields in place.
• Do not operate if crimping dies are worn or damaged.
• Disconnect air supply before changing dies or performing other maintenance.
• Do not allow bystanders around the machine while it is operating.
• Use caution with the foot pedal—be sure to remove your foot until you are ready to
initiate a crimp cycle. The Quick Crimp Pneumatic Crimper can develop more than 6
tons (12,000 lbs.) of force.
• Our Universal Hex Dies (part number 4255UDA & 4255UDB) can be used to crimp
cast copper connectors, heavy-wall copper tube lugs, standard copper tube lugs,
brazed seam lugs and SB, SBX and DIN contacts.
• An additional die set is available to make diamond crimps in these same connectors
(part number 4252D).
• A unique die set is required to crimp lead-free OEM style band terminals
(part number 420506).
• A special die set is also available for brazed seam flag connectors (420579).
Grease
fitting
Roller
Mounting
points
Figure 1
Mounting
point
Spare Parts
420550-2
420550-3
420550-4
420550-5
420550-6
420550-7 Replacement die guard with warning labels
Replacement quick release pin with ring
Replacement upper crimp die shaft with snap ring
Replacement guide plate with nut
Replacement upper die shaft spring
Replacement filter/regulator
Part No. Description