Advent UBTSW1 - Manual (Page 2)

2
Using Your Bluetooth Hands Free Kit
Powering On/Off
The bluetooth kit will automatically turn on when the vehicle’s key is turned to the accessory position and will remain on
until the vehicle’s accessory power is turned off. After turning on, the bluetooth kit will automatically search for phones that
have been paired with it. Since it is possible to have multiple phones paired to the system the order of priority of
connecting will be the latest phone paired, the phone most used with the system, the phone second most used phone with
the system. If the bluetooth kit has not been paired to a phone pairing will automatically activate.
Making a Call
When connected to the bluetooth kit you may use your phone as normal to dial numbers or search your contacts list
or by using Voice Dialing.
Voice Dialing
To activate voice dialing press the ANSWER/END key on the bluetooth keypad, the system will prompt you for a
command. Clearly speak your command (example, “Call Shaun”). The system will then confirm the command and in
this example will then call “Shaun”.
Ending a Call
To end a call press the ANSWER/END key.
Answer a Call
When there is an incoming call the vehicle’s radio will be muted/turned off and the call will ring through the
vehicle’s speaker, to answer press theANSWER/END key.
Ignore an Incoming Call
To Ignore an incoming call press and hold the ANSWER/END key for 2 to 5 seconds.
Redial the Last Number
To redial the last number press and hold the ANSWER/END key for 2 seconds.
Adjusting the Call Volume
Transfer a Call
To transfer a call between bluetooth hands free or normal phone operation press and hold the ANSWER/END key on
the bluetooth keypad for 2 seconds.
Pairing
To activate phone pairing press and hold the ANSWER/END key for 10 seconds, the system will beep 3 times. At
this time you will need to activate pairing on the phone, see your phones owners manual. The PIN code for pairing is
1234 and will need to be entered into your phone at the time of pairing.
*Throughout this manual, ‘press’ refers to pressing for less than 1 second, ‘press and hold’ refers to pressing for 2
seconds.
While in a call, to adjust the volume up/down with the ANSWER/END key, pressing and holding the
ANSWER/END key will automatically raise or lower the volume. When the max volume is reached it is set up
to automatically lower the volume down to the min level. The system will beep 2 times when the min/max
volume levels are reached.