Magikitch'n LPG-60 - Manual (Page 9)

L25-003 Rev 4 (09/12)
7
CONNECTING the GAS LINES to the PROPANE TANKS
A. New propane tanks are shipped empty with no pressure and must be purged of air and filled with propane
per NPGA (National Propane Gas Association) recommendations prior to initial use.
B. Tank rack(s) must be mounted to the charbroiler base (See tank rack instructions).
C. Tank(s) must be mounted securely to the tank rack(s) (See tank rack instructions).
D. Install the black plastic gas connector onto the external thread on the tank valve. Turn it clockwise and
hand tighten.
Leak Testing
E. The plumbing must now be tested for gas leaks before use. Turn all propane tank, burner control and
runner tube control valve(s) to the “off” position. Wet all gas line fittings and connectors with a solution of
soapy water (or commercial leak disclosing liquid). Slowly open the propane tank valve(s) and look for
bubbles or foam at any of the joints in the system. If a leak is found, close the tank valves immediately and
call your local dealer, the ASAP agency or the manufacturer.
F. If the gas connections are leak-free, the unit is ready to use. Follow the lighting instructions in Sect. 7.
Upper hold down bracket
Left side tank rack installed
Right side tank rack installed
Lower tank bracket
Left side tank, regulator and
hose assembly, installed
Right side tank, regulator and
hose assembly, installed
Note the orientation of the hose
assembly in each case