Minka Group F571-DRF - Manual (Page 9)

BEGIN INSTALLATION
MOUNTING OPTIONS
If there isn't an existing outlet box, then read the following instructions. Shut the
power off at the circuit breaker or fuse box.
Secure the outlet box directly to the building structure. Use appropriate fasteners and
building materials. The outlet box and its support must be able to fully support the
moving weight of the fan (at least 50 lbs.). Use a U.L. Listed metal outlet box marked
"Acceptable for ceiling fan support". Do not use a plastic outlet box.
Figures 1,2 and 3 are examples of different ways to mount the outlet box.
Note:You may need a longer downrod to maintain proper blade clearance when
installing on a steep,sloped ceiling. Longer downrods are available from your Minka-
Aire
® dealer.
To hang your fan where there is an existing fixture but no ceiling joist,you may need
to install a hanger bar as shown in Fig. 4 (available at your Minka-Aire
® dealer).
Tools Required: Phillips screw driver; slotted screw driver;pliers;wire cutters; electrical tape.
3
CEILING JOIST
CEILING JOIST
OUTLET BOX
CROSS BRACE
PARALLEL WOOD BRACE
(MIN. 2" THICK)
OUTLET
BOX
CEILING JOIST
OR CROSS BRACE
Fig.1 Fig.2
Fig.3 Fig.4
ANGLED CEILING
MAXIMUM 29
ANGLE PROVIDE
STRONG
SUPPORT
HANGER
OPENING
MUST
BE FACING
UP-SIDE
OUTLET BOX
HANGER BAR
(OPTIONAL) CEILING
JOIST
HANGER
BRACKET