Aqua Flo Therma-Flo EHT User Manual
Page 3
WARNINGS
(may cause serious injuries or death)
•
The power supply must be turned off during the installation process.
•
This pump is wired for 220-240 VAC, 50 Hz, and Single Phase power supply
only. The power supply should be supplied through a Residual Current
Device (RCD) with a rated tripping current not exceeding 30 mA.
•
No part of the pump is to be located above the spa bath during use. Parts
incorporating electrical components, except remote control devices, must be
located or fixed so that they cannot fall into the spa bath.
•
Pump and other parts containing energized or live parts, except parts
supplied with safety extra low voltage not exceeding 12 V, must be
INACCESSIBLE to a person in the spa bath.
•
Pump must be mounted on top of a horizontal and solid surface; fixed
securely using screws or bolts through the 4 mounting holes located on the
base.
•
The appliance is not intended for use by young children or infirm persons
without supervision.
•
Young children should be supervised to ensure that they do not play with the
appliance.
CAUTION
(may cause property damage)
•
This pump is intended for Spa Bath use ONLY, and is not suitable for any
other application.
•
The pump is NOT self-priming; therefore, the water fill-level of the spa bath
must be equal or higher than the pumps suction port (inlet).
•
DO NOT run the pump without water. This may damage pump and its
components.
•
DO NOT open or service the pump. There are no “user serviceable” parts or
assemblies inside. This pump contains dielectric oil used to cool down the
motor. The amount of oil contained herein was precisely measured for
optimum performance. Opening or altering the pump will void the warranty.
•
This pump is a Type Y Attachment. If the supply cord needs to be replaced,
please contact your local authorized dealer.
INSTALLATION
1. Be sure that the requirements under Mounting Preparation section have been
met.
2. The pump is provided with barrel unions to connect the pump’s Suction port
(inlet) and Discharge port (outlet) to the plumbing. The plumbing must be routed
or oriented in a way that when the pump is installed, the port connections are not
subjected to undue stress.
INITIAL START-UP
1. Fill the spa bath with water to the normal operating bath water level.
2. Open all the valves within the plumbing system.
3