Minka Group F579-L-ORB - Manual (Page 17)

8
Fig 17
BLADE INSTALLATION
Step 1. (Fig. 17) Insert the Blade into the Blade Bracket,
the side shank of the Blade Bracket should be
positioned parallel to the edge under the curvature of
the Blade. Align all three holes and secure with the three
screws previously removed. CAUTION: Tighten Screws
with a Screw Driver by Hand, Over- tightening with an
Electric Screw Driver Could Damage the Blades.
Step 2. (Fig. 17) Slide the Blade Bracket / Blade assembly
into the shank and align the hole, securely tighten with
the screw previously removed. Repeat process from
steps 1 and 2 with the other Blade Bracket/Blades.
BLADE
BLADE HOLDER
SCREWS
SCREWS
MOTOR HOUSING SHANK
MOTOR HOUSING