Martin Universal Design U-7100 Avanti Designer Table - Manual (Page 4)

Assembly Instructions continued:
STEP 10] Attaching Top Braces
When attaching the [2] Drawing Top Braces [G], position the
drawing board brace in the position shown here:
PLEASE NOTE:
Correct attachment of Drawing Top Braces will have
large holes on Drawing Top Brace facing downward.
STEP 11] Turning Base over
PLEASE NOTE: BEFORE TURNING BASE OVER
ONTO DRAWING BOARD: MAKE SURE DRAWING
BOARD BRACES ARE IN A HORIZONTAL
POSITION AND KNOBS ARE TIGHTENED.
Before securing base of table to 30” x 42” Drawing Board top, you
must center the base to the top.
Front Edge of Top
Rear Edge of Top
Center base by measuring 7” in [Measurement Y] from outside
edges of Drawing Board to outside edge of Base Braces and
5-1/8” in from front edge of drawing board to front edge of Base
Brace and 5-1/8” in from rear edge of drawing board to rear
edge of base Brace. See illustration below. Secure using [4]
Long Wood Screws [GG] per Base brace. This top is 30” x 42”.
Y = 7”
Y = 7”
X = 5-1/8” X = 5-1/8”
STEP 13] Attaching Tilt Adjustment Rods
to Drawing Board
Use two people with this next step. Lay top on carpeted flat surface.
Carefully turn completed base assembly up and over and place
on top of bottom side of drawing board.
PLEASE NOTE: Both sides of Drawing board can be the bottom
side. Choose best looking for Top Side.
STEP 12] Attaching Base to Drawing Top
Base should look and be positioned to Drawing Board as
pictured below.
Attach to the inside of the Side Support [D] using the [2]
remaining knobs, washers and bolts [F]. Insert bolt through
hole on inside of Drawing top Brace, making sure bolt goes
through side support [D]. Finish by attaching washer and then
female knob.
To make your table top tilt: Loosen the [2] black knobs (with
tilt rods through them), proceed by holding onto the front
edge of the top. Tilt top until desired position is reached.
Tighten [2] black plastic knobs.

STEP 14] Table Top Tilt Adjustments
Attach metal tilting brackets to top using [2] each small wood
screws [II] per bracket as shown above. PLEASE NOTE: Break
Table Top Surface by making a small hole in top surface where
screw will go in with hammer and a nail.
To adjust the height of your table, loosen the lever slightly.
PLEASE NOTE: When loosening the lever, the table
will want to lower because of the weight of the top.
Carefully, loosen lever and support table top with
hands and lower or raise until desired height. Re-
tighten Lever to secure. This adjustment is safest with
another adult helping.

STEP 15] Table Height Adjustment
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: [email protected] • visit us at www.MartinUniversalDesign.com
D
G
F
Attach
Bracket on
Tilt
Adjustment
Rods into
Top