Martin Universal Design U-9102 KIDS' DUAL ART CENTER - Manual (Page 2)

4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: [email protected] • visit us at www.MartinUniversalDesign.com
09/201
1- RPI
Kids’ Dual Art Center Assembly Instructions
Model # U9102
TO ASSEMBLE:
1. Attach 2 bottom legs (E) to green
chalkboard side of upper easel
assembly (L), using 4 ea. 3/16” x 2”
bolts (F) and tighten with washers
(H) and wing nuts (I). See FIG 1.
NOTE: Make sure the same hole
is used on each leg for proper
height. i.e. if you use the middle
hole on one leg use the middle
hole on all legs.
2. Attach 2 bottom legs (E) to white
board side of upper easel assembly
(L), using 2 ea. 3/16” x 2 1/2” bolts
(G), insert these bolts into holes near
bottom of white board, tighten with
washers (H) and wing nuts (I).
See FIG 1B.
NOTE: Make sure the same hole
is used on each leg for proper
height. i.e. if you use the middle
hole on one leg use the middle
hole on all legs.
Enclosed are all the components necessary to assemble your new Deluxe Kids’
Dual Art Center #U-9102. Prior to assembly make sure all your parts are enclosed
by checking them against the parts list. Tools needed to assemble are a Phillips
Screwdriver and a Hammer.
F
FIG 1.
green
chalkboard
side
E
G
FIG 1B.
White
Drawing
Board Side
E
H
I
2