Martin Universal Design CAMBRIDGE I PRINT RACK - Manual

CAMBRIDGE I & II PRINT RACK
Assembly Instructions - Page 1
Part A
This side has the hinges attached
Part B
This side has the [2] screws & nuts attached
STEP 1.
Begin by removing any protective packaging
found wrapped around the print rack parts and
discard.
Remove the [2] Screws and nuts from Part B.
Part B
Part A
STEP 2.
Place Part B in-between the legs of Part A as
shown in FIG 1 at right.
FIG 1.
STEP 3.
Secure by inserting the screw through the side
outer hole of Part A and through the hole in the
side of Part B. Secure with nut. NOTE: Hold Nut
in place with wrench while tightening screw with
screwdriver. See FIG 2.
Part A
Part B
Screw
Nut
FIG 2.
Page 1
Martin/F. Weber Co. • 4444 Lawton Avenue, Detroit, MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709 • E-mail:[email protected]
www.MartinUniversalDesign.com • www.weberart.com • Made in China
Created OCT07 RPI
ASSEMBLY INSTRUCTIONS ARE THE SAME
FOR BOTH MODEL I & MODEL II