Martin Universal Design 91-8006 VESUVIO CHAIR - Manual (Page 2)

5.
1.
Place 5-star base (E) face down and
push [5] castors (C) into each position.
E
C
THIS STEP IS ONLY FOR
MODEL 91-8006 ONLY.
Before attaching foot ring (F) to cylinder
(B). Begin by loosening the knob on the
foot ring and make sure the plastic ringis
inserted properly, by making sure the
cut ends of the insert run parallel with
the weld on the inside of the foot ring
hole. The insert should be already in the
foot ring. NOTE: THIS MUST BE
POSITIONED PROPERLY TO ALLOW
THE CYLINDER TO SLIDE THROUGH
THE INSERT EASILY.
2.
knob on foot ring
weld
Cut ends of plastic
insert must run parallel
with the weld.
4.
PLEASE NOTE: If you have model
number 91-8009, your assembly will
be the same but instead of foot ring
you will need to place black bellows
over top of cylinder after inserting
cylinder into base.
Insert wider end of cylinder into hole in
base, as shown above.
Model #
91-8009
Model #
91-8006
Attach mechanism (A) to seat (H) using
[4] 1.5” hex head screws (J). See picture
above for specified locations that are
circled. Tighten with hex wrench.
6.
7.
8.
Attach seat/backrest/armrest assembly
to cylinder by inserting top of cylinder
into hole on bottom of seat
mechanism.
Weight of sitting on seat will secure seat
assembly to cylinder.
NOTE: 2 Paddles below seat
are for seat height adjustment
and Backrest tilt adjustments.
NOTE2:
PERIODIC RE-TIGHTENING
of Armrests screws may be
needed throughout use of
chair over the years.
Revised 05/06 RPI
3.
Slide cylinder down through foot
ring and tighten knob . After chair is
assembled completely, you may adjust
foot ring to desired height.
Attach backrest (G) to seat mechanism,
by inserting backrest support bar into
oval hole in mechanism. Tighten knob
on mechanism to secure.
1-1/8” 1-1/8”
1-1/2” 1-1/2”
Plastic Washer
Seat Bottom
Screw
Metal
washer
Armrest bracket
Attach armrests to bottom side of seat.
Each Armrest (M) uses [3] screws and
[3] washers. Use [1] 1-1/8” screw and 1
washer in location indicated above.
Use [2] each 1.5” screws, [2] washers
and [2] thick plastic washers in location
show above.
Tighten with hex-wrench.
NOTE: [2] Thick plastic washers
are to be positioned between the
armrest and seat bottom, for each
armrest. See below illustration for
proper locations.