ACE Controls SA Adjustable 3" Bore Series User Manual
ACE Controls For the car
Air-Oil Tank Installation Instructions
CAA & CSA Self-Compensating and
AA & SA Adjustable 2” & 3” Bore Series
AIR-OIL TANK INSTALLATION (Figure 1)
Self-compensating models CAA and CSA as well as
adjustable models AA and SA are pre-filled with ATF
but
must be connected to an air-oil tank before use.
Install the proper ACE air-oil tank as close as possible to,
and physically higher than the shock absorber. The line
connecting the shock absorber to the air-oil tank must
be free of kinks and loops. The inside diameter of this
line must be equal to, or greater than, that of the port
in the shock absorber.
Do not put a shut-off valve between the shock
absorber and the air-oil tank. Install a check valve in
the air line to the air-oil tank and plug the extra ports of
the tank. Fill the tank with ATF to the fill mark and charge
the system to between 50 - 100 psi (3.4 - 6.8 bar).
AIR EXHAUST CIRCUIT FOR MODELS CAA and
AA SHOCK ABSORBERS (Figure 2)
If the rod is to remain in the shock absorber after
decelerating the load, this type of installation is
necessary. Avoid overfilling the air-oil tank. If not built in,
a special ACE check valve should be used to eliminate
misting of oil out of the air-oil tank.
PROPER AIR-OIL TANK SIZE
Refer to the chart below for proper air-oil tank size.
Maximum efficiency of operation can be obtained by
carefully following these instructions:
23435 Industrial Park Drive
Farmington Hills, Michigan 48335
tel:
248.476.0213
fax:
248.476.2470
www.acecontrols.com
Bore
2”
3”
Air-Oil
Tank
AO-6-91
AO-6-91
Air-Oil Tank
(Re-circulating Circuit)
AO-6-91
AO-6-91
Figure 1
R
Fill Plug
Air-Oil Tank
Plug
Plug
Check Valve
above this line
Do not fill
WARNING
Do not use near open flame
contents may be flammable
Free
Flow
Inlet Port
Figure 2
Air-Oil Tank
above this line
Do not fill
Do not use near open flame
contents may be flammable
WARNING
CV 3/4-F
T
R
T
3-Way Normal
Closed Valve
F
SOL
Exhaust
Supply
World leader in deceleration technology
ISO 9001:2000 Certified
ACE Controls Inc.