Allied Telesis AT-WR4500 - Manual (Page 91)

AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers 91
RouterOS v3 Configuration and User Guide
Example
Consider the following configuration:
Reserved for dial in
10.0.0.230..240
Pppoe-inX addresses
10.0.0.217/32
10.0.0.217/24
ether1
10.0.0.1/24
Internet
Laptop
10.0.0.231/24
Server
10.0.0.2/24
WS
10.0.0.230/24
Figure 12: Proxy ARP with PPPoE
The Router setup is as follows:
admin@AT-WR4562] ip arp> /interface ethernet print
Flags: X - disabled, R - running
# NAME MTU MAC-ADDRESS ARP
0 R eth-LAN 1500 00:50:08:00:00:F5 proxy-arp
[admin@AT-WR4562] ip arp> /interface print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE MTU
0 eth-LAN ether 1500
1 prism1 prism 1500
2 D pppoe-in25 pppoe-in
3 D pppoe-in26 pppoe-in
[admin@AT-WR4562] ip arp> /ip address print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 10.0.0.217/24 10.0.0.0 10.0.0.255 eth-LAN
1 D 10.0.0.217/32 10.0.0.230 0.0.0.0 pppoe-in25
2 D 10.0.0.217/32 10.0.0.231 0.0.0.0 pppoe-in26
[admin@AT-WR4562] ip arp> /ip route print
Flags: X - disabled, I - invalid, D - dynamic, J - rejected,
C - connect, S - static, R - rip, O - ospf, B - bgp
# DST-ADDRESS G GATEWAY DISTANCE INTERFACE
0 S 0.0.0.0/0 r 10.0.0.1 1 eth-LAN
1 DC 10.0.0.0/24 r 0.0.0.0 0 eth-LAN
2 DC 10.0.0.230/32 r 0.0.0.0 0 pppoe-in25
3 DC 10.0.0.231/32 r 0.0.0.0 0 pppoe-in26
[admin@AT-WR4562] ip arp>
5.1.5
Unnumbered Interfaces
Description
Unnumbered interfaces can be used on serial point-to-point links. If your AT-WR4500 ROUTER is not
equipped with such interfaces, please disregard this description. A private address should be put on the