Barksdale Series 20597 User Manual

Page 8

Advertising
background image


Barksdale, Inc. 3211 Fruitland Avenue, Los Angeles CA 90058 (800)835-1060 www.barksdale.com Bulletin No. 272353-B, 4-3-14

8

Disassembly
1. Disconnect all fittings from the regulator and pilot motor
2. Turn locking device(31) counterclockwise first to unlock. Turn handle(48) counterclockwise to remove load

from compression springs

3. Remove spring housing bolts(14)
4. Lift the spring housing assembly(21) together with spring(25, 26) and SPRING gland(22)
5. Remove

flanges

a. Remove bolts(14) from inlets, vent(42) and blind(35) flanges, pull the flanges out
b. Remove bolts(14) from bottom(47) flange, pull out flange
c. Note: If using major repair kit, remove bolts (43) from inlet and vent flange (42) and blank flange (35).
Remove inlet plate (44) vent plate (40) and blocking plate (36).

6. Remove piston gland(15) and push out the slide assembly(3, 13) towards the top, Remove piston(13) and

slide(3)

7. Take out pressure seals(8, 7) from slide(3)
8. Uninstall all soft goods (o-rings and back-up rings)

Cleaning and Inspection
1. Thoroughly clean and inspect the slide(3) and piston assembly(3, 13). Look for signs of wear, replace if

necessary

2. Thoroughly clean and inspect the wear plates(44, 40, 36) on the internal side of the inlet(42), vent(42) and

plain(35) flanges. Look for signs of wear or scratching, replace if necessary.

3. Inspect all pressure seals(8, 7) for wear, if signs of damage, replace.
4. Check all o-rings, back-up rings and washers, replace if necessary.

Re-assembly
1. Lightly lube all soft goods from Repair Kit with petroleum based lube (mobile lube)
2. Re-install all o-rings (wherever back-up rings are used, refer to exploded view drawing to assure proper

orientation of back-up rings in relation to o-rings)

3. If using major repair kit, ensure o-rings (41) are installed prior to aligning all plates and flanges and secure

flanges with bolts (37), torque to 140-180 in-lbs.

4. Re-install pressure seals(8, 7), spring (4) and piston vent(9) back into the slide(3) (make sure back-up o-

rings are not extruding)

5. Insert bottom flange(47) first.

Advertising