APTech Panel Mount Plate - AK1000T - Manual (Page 2)

Operation Manual Panel Mounting Gas Pressure Regulators
Manual 15000014 Rev 1 Page 2 of 5
Figure 1. Regulator with panel mount nut. Regulator body not shown.
C. Panel Mount Ring – SL5200 Model Regulators
1. Adjust the regulator to full open by turning the knob (#2, refer to Figure 2) clockwise until it
stops.
2. Using a 5/64 inch hex key wrench, unscrew the set screw (#1) 2-3 turns.
3. Unscrew and remove the knob from the regulator.
Note: Washers (#4) may be installed on the stem (#3) to limit the maximum adjustable outlet
pressure. Do not remove these washers.
4. Using a 5/64 inch hex key wrench, loosen two side set screws (#6) on opposite sides of the ring
and remove the panel mount ring (#5).
5. Place the regulator through the panel hole cut out. Recommended hole cut out diameter is 1.18 “.
6. Replace the panel mount ring onto the unit. While pressing the ring down, tighten two side set
screws.
Note: Make sure, that the set screws are NOT aligned with the bonnet port (#8).
7. Using a 5/64 inch hex key wrench, tighten two top set screws (#7) to secure the panel mount.
8. Place the knob back on the stem, and turn the knob clockwise until it stops.
9. Tighten the set screw.
10. Close the regulator by turning the knob counter clockwise until it stops.