Acura Music Link BII31179-34943 - Manual (Page 8)

8 of 8
BII 31179-34943 (0704) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.
5527100B
BUS CABLE 14-PIN
CONNECTOR or
Y-HARNESS ADAPTER
14-PIN CONNECTOR
VEHICLE
CONNECTORS
ANTENNA
LEAD
SELF-TAPPING
SCREW
BOLT (4)
AUDIO
UNIT
adapter 14-pin connectors.
• Secure the Y-harness adapter to the vehicle
harness with a wire tie.
• Bundle up the excess bus cable, and secure it to
the vehicle harness with the two wire ties.
25. Reinstall the glove box.
26. Connect the vehicle connectors and bus cable
14-pin connector (or Y-harness adapter 14-pin
connector) to the audio unit, and reinstall the
audio unit.
27. Check that all wire harnesses are routed properly
and all connectors are plugged in.
28. Reconnect the negative cable to the battery.
29. Enter the client’s radio anti-theft code. Reset the
radio station presets and the clock.
30. Reinstall all removed parts.
31. Turn the audio unit ON. Check that CDC EJECT,
or CD4 EJECT is shown on the audio unit display
while in the AUX mode (the Music Link is
recognized as an accessory CD changer).
NOTE: Whenever the battery is disconnected, the
driver’s AUTO function is disabled.
32. Start the engine. Push down on the driver’s
window switch until the window is fully open.
33. Pull up on the driver’s window switch fully to close
the window completely, then hold the switch for
2 seconds or more.
34. Test the window AUTO function.
5607131B
VEHICLE
HARNESS
WIRE
TIE
BUS CABLE
(Bundle up excess.)
Y-HARNESS
ADAPTER
WIRE
TIE
VEHICLE
HARNESS
WIRE
TIE
5607091B
TAB
STOPPER
BOLTS
GLOVE
BOX
SELF-TAPPING
SCREW
DAMPER
ROD