Goulds Pumps VIC - IOM - Manual (Page 6)

Environmental safety
The work area
Always keep the pump station clean to avoid and/or discover emissions.
Recycling guidelines
Always recycle according to these guidelines:
1. If the unit or parts are accepted by an authorized recycling company, then follow local recycling laws
and regulations.
2. If the unit or parts are not accepted by an authorized recycling company, then return them to the
nearest ITT representative.
Waste and emissions regulations
Observe these safety regulations regarding waste and emissions:
• Dispose appropriately of all waste.
• Handle and dispose of the pumped fluid in compliance with applicable environmental regulations.
• Clean up all spills in accordance with safety and environmental procedures.
• Report all environmental emissions to the appropriate authorities.
Reference for electrical installation
For electrical installation requirements, consult your local electric utility.
User health and safety
Safety equipment
Use safety equipment according to the company regulations. Use this safety equipment within the work
area:
• Helmet
• Safety goggles (with side shields)
• Protective shoes
• Protective gloves
• Gas mask
• Hearing protection
The work area
Observe these regulations and warnings in the work area:
• Always keep the work area clean.
• Pay attention to the risks presented by gas and vapors in the work area.
• Avoid all electrical dangers. Pay attention to the risks of electric shock or arc flash hazards.
Product and product positioning requirements
Observe these requirements for the product and the product positioning:
• Never operate a pump unless safety devices are installed.
• Never operate a pump unless a coupling guard is installed.
• Never force the piping in order to make a connection with a pump.
• Never start a pump without the proper submergence.
• Never run a pump below the minimum rated flow or with any suction or discharge valve closed.
Electrical connections regulations
Electrical connections must be made by certified electricians in compliance with all international, national,
state, and local regulations.
Introduction and Safety (Continued)
4 Model VIC Installation, Operation, and Maintenance