Trademark Tools SINGLE DRAWERWORKBENCH - Manual (Page 4)

TOOL BOARD ASSEMBLY
STEP 1
Place the left holed back board support (15)
and the right holed back board support (16)
on a level surface.
STEP 2
Mount a cross member (13) between
the holed back board supports. Fasten the
corners using bolts, washers and nuts provided.
STEP 3
Place the holed back board (D) in between
the frames (as shown).
Use two M6 x 15 mm bolts (type 1),
washers and nuts at the top to fasten the
holed back board (D) to the frame.
STEP 4
Position the left top cantilever arm (17)
and the right top cantilever arm (18)
in the corners of the frame.
STEP 5
Mount the top rail (13) between the
two top cantilever arms. Fasten the
corners of the frame using the bolts,
washers and nuts as shown.
STEP 6
Mount the top board (C) on top of the
frame using the wood screws (type 5).
14B
14B