Brocks Performance CT Single Full System 16" QuietKore Muffler S1000RR/R (10-14) - Manual

DOCUMENT ID 994445
Page 1 of 4
Installation Instructions for the
BMW S 1000 RR (2010-11) CT Single Exhaust System
CHECK PACKAGE CONTENTS
1. One (1) Left Side Header (Cylinders 1 & 2)
2. One (1) Right Side Header (Cylinders 3 & 4)
3. One (1) Collector (Y-Pipe)
4. One (1) Mid-Pipe
5. One (1) CT Single Muffler
6. One (1) Package Containing Flanges, Collars, Springs, Spring
Puller, Bracket and Hardware
7. One (1) Instruction Package
If any parts are missing, contact Brock’s Performance Products.
Brock’s Performance CT Single
***PAIR BLOCK OFF MUST BE PERFORMED TO PREVENT PREMATURE EXHAUST FAILURE***
www.brocksperformance.com/Instructions/S1000RR/994471.pdf
PRE-ASSEMBLE HEADERS AND COLLECTOR TO ENSURE PROPER FIT BETWEEN ALL PARTS
Brock’s Performance carefully inspects each
system prior to shipping, we recommend that
you test fit your system prior to installation.
Apply WD-40 to the joints to ease assembly,
adjustment, and/or disassembly.
REMOVE BODYWORK
Consult a factory service manual for additional information. To remove
the left lower fairing, remove the five (5) mounting bolts from the
inside and bottom of the lower fairing pointed at by the red arrows.
Remove the seven (7) mounting bolts from the outside of the lower
fairing in the red circles. Remove the one (1) plastic fastener in the
green circle by unscrewing the center pin then pulling the fastener out.
Pull out on the fairing to detach from the push pin pointed at by the
green arrow. Pull the fairing out just far enough to access the turn
signal wire located on the top of the radiator mount and unplug. The
left lower fairing can now be removed.
Brock’s Performance Products • 4064 East Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062