Brocks Performance ShortMeg 2 Full System 14" Muffler S1000RR (10-14) - Manual

DOCUMENT ID 994406
Page 1 of 4
Installation Instructions for the
BMW S 1000 RR (2010) Alien Head and Short Meg Exhaust System
CHECK PACKAGE CONTENTS
1. Four (4) Header Mount Flanges (Installed in Headers)
2. One (1) Left Side Header (Cylinders 1 & 2)
3. One (1) Right Side Header (Cylinders 3 & 4)
4. One (1) Collector (Y-Pipe)
5. One (1) Alien Head or Short Meg Muffler
6. One (1) Package Containing Springs, Spring Puller, Bracket and
Hardware
7. One (1) Instruction Package
If any parts are missing, contact Brock’s Performance Products.
Brock’s Performance Alien Head
PRE-ASSEMBLE HEADERS AND COLLECTOR TO ENSURE PROPER FIT BETWEEN ALL PARTS
Brock’s Performance carefully inspects
each system prior to shipping, we
recommend that you test fit your system
prior to installation. Apply WD-40 to the
joints to ease assembly, adjustment,
and/or disassembly.
REMOVE BODYWORK
Consult a factory service manual for additional information. To
remove the left lower fairing, remove the five (5) mounting bolts from
the inside and bottom of the lower fairing pointed at by the red
arrows. Remove the seven (7) mounting bolts from the outside of the
lower fairing in the red circles. Remove the one (1) plastic fastener in
the green circle by unscrewing the center pin then pulling the
fastener out. Pull out on the fairing to detach from the push pin
pointed at by the green arrow. Pull the fairing out just far enough to
access the turn signal wire located on the top of the radiator mount
and unplug. The left lower fairing can now be removed.
Brock’s Performance Products • 4064 East Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062