Brocks Performance ShortMeg Full System 14" Muffler CBR-1000RR (12-14) - Manual

Document ID 996512
Page 1 of 6
Brock’s Performance • 4064 E. Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062
CBR1000RR (12-14) Alien Head™/ShortMeg™ Full System Installation Instructions
Step 1: Check Package Contents: The Alien Head™ or ShortMeg™ system is shown below.
The Package Contents Include (see figure 1):
1. One (1) Left Side Primary (cylinders 1 & 2)
2. One (1) Right Side Primary (cylinders 3 & 4)
3. One (1) Collector
4. One (1) Elbow
5. One (1) Alien Head/ShortMeg Muffler
6. Four (4) Flanges
7. One (1) Package Containing Springs, Spring Puller & PAIR Block Off Cap
8. One (1) Installation Instruction Package
If any parts are missing, contact Brock’s Performance.
Note: A slight ovaling of the tubing can occur during the manufacturing process, this is normal.
A twisting motion may be required during assembly/disassembly.
Step 2: Pre-Assemble Primaries, Collector, and Elbow to Ensure Proper Fit Between
All Parts:
The pre-assembled system is shown (see figure 2.) Pre-assembly helps to detect any potential
shipping damage and ensures that all parts fit properly. Apply WD-40® to the pipe joints to ease assembly,
adjustment, and especially disassembly.
Caution: During the following steps, the bodywork should remove with ease. If you
feel resistance, stop and assess the situation before continuing.