Brocks Performance ShortMeg 2 Full System 14'' Muffler VMAX (09-14) - Manual

DOCUMENT ID 994341
Page 1 of 3
Installation Instructions for the
VMAX (2009-11) Alien Head and Short Meg Exhaust System
CHECK PACKAGE CONTENTS
1. Two (2) Header Mount Flanges (Installed in Head Pipes)
2. One (1) Left Side Head Pipe (Cylinder 1)
3. One (1) Right Side Head Pipe (Cylinder 4)
4. One (1) Left Side Primary Header/Collector
5. One (1) Right Side Primary Header/Collector
6. One (1) Secondary Collector
7. One (1) Mid-pipe
8. One (1) Gen4 Muffler
9. One (1) Package Containing Springs, Spring Puller, and
Hardware
10. One (1) Instruction Package
If any parts are missing, contact Brock’s Performance Products.
Brock’s Performance Short Meg System
PRE-ASSEMBLE HEADERS AND COLLECTOR TO ENSURE PROPER FIT BETWEEN ALL PARTS
Brock’s Performance
carefully inspects each
system prior to shipping,
we recommend that you
test fit your system prior
to installation. Apply
WD-40 to the joints to
ease assembly,
adjustment, and/or
disassembly.
REMOVE THE MUFFLERS
Remove the exhaust covers from the front of the mufflers. Loosen the clamp retaining bolt, the bolt only needs to be
loosened not removed. Remove the muffler mounting bolt and slide the muffler rearward to remove, apply a twisting
force to ease removing the muffler. Then proceed to the other side of the bike and repeat.
REMOVE THE CATALYTIC CONVERTER
Remove the EXUP cables from the EXUP servo motor, the motor cannot be removed unless an EXUP servo motor removal
module is purchased to replace it. Disconnect the oxygen sensor from the main wiring harness. The Power Commander 5
comes with an oxygen sensor removal module that will plug into the main harness. Loosen the clamps connecting the
Brock’s Performance Products • 4064 East Patterson Road • Dayton, OH 45430 • Phone: 937-912-0054 • Fax: 937-912-0062