Edgecraft Chef's Choice eXact-V 415 - Manual (Page 8)

tensioner (8) on the knife guiding assembly to its
bottom position. Note that the right side of the knife
guiding assembly must fit between the lock tab
(12) and the two standing ribs on the right. Insert
the guiding assembly on top of the rods with the
spring assembly facing up. Insert the bottom end of
the assembly’s post between the two large snaps
(adjacent the top end of the sharpening rods), then
lower and press the top end of the assembly down
and into position as shown in Figure 7. When this is completed the bottom cover
will fit and snap securely in place onto the bottom.You can lower the opened
hand guards by pulling them slightly upward, laying them flat and then sliding
forward to a locked position.
Care of Sharpener
The abrasive elements should always be used totally dry. Always wash and dry
knives before sharpening if they contain any food, oil or other material that can
be transferred onto the diamond abrasive surfaces.
If, however the abrasive surfaces become loaded with any foreign material, the
rods can be removed and their surfaces cleaned with a tooth brush and a mild
detergent/water solution. Clean the surfaces well and allow to dry completely.
Periodically clean the exterior surfaces of the sharpener with a soft damp cloth
to remove dust and any filings created by sharpening.
8
Limited Warranty: Used with normal care, this EdgeCraft product is guaranteed against defective material
and workmanship for a period of one (1) year from the date of original purchase (“Warranty Period”). We will
repair or replace, at our option, any product or part that is defective in material or workmanship without charge
if the product is returned to us postage prepaid with dated proof of purchase within the Warranty Period. This
warranty does not apply to commercial use or any product abuse. ALL IMPLIED WARRANTIES, INCLUDING
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO
THE WARRANTY PERIOD. EDGECRAFT CORPORATION SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSE-
QUENTIAL DAMAGES. Some states do not allow limitations on how long an implied warranty lasts and some
states do not allow exclusions or limitation of incidental or consequential damages, so the above limitations or
exclusions may not apply to you. This Limited Warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
This product may be covered by one or more EdgeCraft patents and/or patents pending as marked
on the product.
© EdgeCraft Corporation 2012 A12 F602960
Figure 8.
12
Push here to
release post (6)
Push here to
release post (6)