Figure 14 – loading media - peal and present – AMT Datasouth 400 User Manual
Page 23
User's Guide 23
Loading Media when Peel and Present Option is Installed
1.
Follow the same procedures in "Loading Media" up until step 11, close and lock the
print head module.
2.
Peel off 6 inches of labels from its backing.
3.
Thread the label backing over the platen roller, over the Peel and Present Bar then back
under the Peel and Present Bar towards the platen.
4.
Turn on the power to “1” position.
5.
With the print head module still open, press the FEED key. The printer will advance the
backing. Once the label backing comes out of the front of the printer, turn off the power
to “O” position.
6.
Close and lock the print head module by pressing firmly until the right and left Print
Head Latches snap shut.
7.
Close the Media Access Cover.
8.
Turn on the power to “1” position.
9.
Press the FEED key to feed out the first label in the printer.
Note: For the Peel and Present mode to function properly the Present Sensor must be
enabled. Refer to the section Feature Management Mode for instructions on how
to change the Present Sensor feature.
Figure 14 – Loading Media - Peal and Present
Label
Backing