Altinex MX2426CV - Manual (Page 10)

SWITCHERS
9
7 Can power
input be
configured
for 220V? The MX2426CV has an
internal power supply capable
of accepting either 110V or
220V through the selection
switch, changing the location
of the fuse box.
8 May I rack
mount this
unit? Yes, if desired, you may order
Rack Ears for single unit
(part#DA1292FC) from
optional accessories.
CABLES AND ACCESSORIES 9
Model No. Description
RACK MOUNTING ACCESSORIES
DA1292FC 1U Rack mount ears for single unit.
POWER CABLES
PC5301US Power cable for US
PC5302UK Power cable for England
PC5303AU Power cable for Australia
PC5304GR Power cable for Germany
RC5205CV Judge Override Button (with 50 feet
cable)
RC5206CV Monitor Status Display
MALE TO MALE VGA CABLE
CB3703MR 3 feet
CB3706MR 6 feet
CB3712MR 12 feet
CB3725MR 25 feet
CB3750MR 50 feet
CB3775MR 75 feet
CB37100MR 100 feet
CB37150MR 150 feet
FEMALE TO FEMALE VGA CABLE
CB3803HR 3 feet
CB3806HR 6 feet
CB3812HR 12 feet
CB3825HR 25 feet
CB3850HR 50 feet
CB3875HR 75 feet
CB38100HR 100 feet
CB38150HR 150 feet
MALE TO FEMALE VGA CABLE
CB3903HR 3 feet
CB3906HR 6 feet
CB3912HR 12 feet
CB3925HR 25 feet
CB3950HR 50 feet
CB3975HR 75 feet
CB39100HR 100 feet
CB39150HR 150 feet
VGA TO RGB ADAPTER CABLES
MS8102CA 15-pin HD Male to 5 BNC Male, 6 feet
MS8104CA 15-pin HD Male to 5 BNC Male, 12
feet
MS8105CA 15-pin HD Male to 5 BNC Male, 50
feet
MS8106CA 15-pin HD Male to 5 BNC Female, 6
feet
GENDER CHANGERS
MS8144MG 15-pin HD/VGA Male to Male
MS8145MG 15-pin HD/VGA Female to Female
TROUBLESHOOTING GUIDE 10
•
Please make sure that the input signal formats
are the same for the input (source) and the
output (display).
•
Please make sure that the input signal
amplitude levels are as follows:
1. RED, GREEN, and BLUE are less than
1.5 V
2. HSYNC & VSYNC are less than 5.0 V
•
Please use the appropriate the input voltage:
110 VAC or 220 VAC.
•
Make sure that the cable is made according to
the manual, where RX pin of the MX2426CV is
connected to TX pin of the computer.
•
If controlling the unit by RS-232 command,
make sure there is minimum delay of 100
millisecond before sending the next command.
•
If you do not see picture on the screen make
sure you have selected both sources (Plaintiff
or Defendant) and one out of six displays.
•
Please make sure that the proper quality of
cables is used. We recommended Altinex
made cables for the best results.
•
If a problem arises after continuous usage at
higher voltage, higher temperature, higher
humidity, or at other extreme environmental
conditions, please correct the problem.