Configuration – ADTRAN Cable T1 ESF CSU ACE User Manual
Page 30
Chapter 4. Operation
30
T1 ESF CSU Rackmount User Manual
61202066L1-1B
Figure 4-1. Display of Terminal Main Menu
1 =STATUS 2= TEST
3=CONFIG
Figure 4-2. Display of DATAMATE Main Menu
Configuration
The Tl ESF CSU RM has nine network options and three CPE options
(See Figure 4-3 and Figure 4-4 on page 31). These options are set from the
terminal or DATAMATE interface under the NETWORK or CPE options.
To enter the Configuration menu from the main menus shown above,
select 3 and press
Enter
. The individual options are described following
the Configuration menus shown below. To change any of the options,
select the option number and press
Enter
. A list of choices is then
displayed. Select the proper configuration parameter from this list.
Tl ESF CSU TERMINAL INTERFACE
1 STATUS
2 TESTS
3 CONFIG
The CPE is also referred to as data terminal equipment
(DTE).