Rugged Ridge HD Steering Box Mount, 76-86 Jeep CJ Models - Manual

1976 – 1986 CJ H/D Steering Box Bracket Instructions
P/N: 18003.10
Parts List: (1) H/D Steering Box Bracket (4) 7/16” Lock nut
(1) 5/8” x 2 ½” Bolt (10) Flat washer
(1) 5/8” Flat washer (2) 7/16” x 1” Hex head bolt
(3) Tall spacer .700” (3) 7/16” x 2” Hex head bolt
(2) Short spacer .275” (1) Outer frame clamp
(3) 7/16” x 2 ½” Stud
(1) 7/16” x 2” Stud
NOTE:
The Rugged Ridge CJ Heavy Duty steering box bracket has been manufactured
using 3/8” welded plate steel for superior strength and durability. With proper
installation this unit will greatly improve the weak steering mount offered by the
OE three piece bracket system. Please take the time to read over this instruction
prior to installing this product. It will be necessary to remove your steering box
from the frame and it is recommended that the proper step be followed. A service
manual is highly recommended.
Installation can be done with box still attached to the lower steering shaft and power
steering hose, but great care should be taken to avoid any damage to these
components.
If your vehicle is equipped with a winch it may be necessary to remove the winch
and mounting plate to install the H/D steering box bracket.
Pg. 1