Rugged Ridge Rear Corner Guards, Body Armor, 97-06 Jeep Wrangler User Manual
Rugged Ridge For the car
11650.01-11650.02 Installation Instructions
Step 1: Remove both left and right side rear taillight assembles. This will require
the removal of 3 bolts for each light that are assessable from the inside of the tail
light assembly and from the upper inside of the fender. The lower plastic fender
cover can be pulled back without removing. The left side license plate holder and
fuel filler neck will also be removed.
Step 2: Clean mounting surface with a strong cleaner or rubbing alcohol. Avoid
areas that the product will not be adhered to.
THIS MUST BE DONE FOR ADHESIVE TAPE TO PROPERLY STICK.
FAILURE TO CLEAN COULD RESULT IN POOR ATTACHMENT AND
FAILURE OF PRODUCT TO STAY ATTACHED.
Allow area to dry completely before attaching body armor.
Pg.1