Rugged Ridge Rocker Side Panels, Body Armor, 97-06 Jeep Wrangler (TJ) - Manual

Part Number 11650.05 (Rocker Side Panel Kit)
Step 1: Remove the two fender flare extensions from the body. Extensions are
held in place by three bolts located outside of the Jeep® and are assessable
from underneath the flare extensions.
Flare extensions can be reinstalled, but holes will need to be drilled in side
rocker armor after they have been installed.
Step 2: Clean mounting surface with a strong cleaner or rubbing alcohol. Avoid
areas that the product will not be adhered to.
THIS MUST BE DONE FOR ADHESIVE TAPE TO PROPERLY STICK.
FAILURE TO CLEAN COULD RESULT IN POOR ATTACHMENT AND
FAILURE OF PRODUCT TO STAY ATTACHED.
Allow area to dry completely before attaching body armor.
Pg.1