Rugged Ridge Hood Guard, Body Armor, 97-06 Jeep Wrangler - Manual

11650.17 (Hood Stone Guard)
Installation Instructions
Step. 1
Clean mounting surface with a strong cleaner or rubbing alcohol. Avoid areas that the product will not be
adhered to.
THIS MUST BE DONE FOR ADHESIVE TAPE TO PROPERLY STICK. FAILURE TO CLEAN
COULD RESULT IN POOR ATTACHMENT AND FAILURE OF PRODUCT TO STAY
ATTACHED.
Allow area to dry completely before attaching body armor.
TOOLS NEEDED : (1) Drill , (1) 7/64” drill bit, and (1) Phillips Head screw driver.
Part number 11650.17 (Hood Stone Guard)
Step.2
Test fit the Hood Guard to the vehicle before removing the plastic backing film. This will aid in aligning
the piece properly before securing with the two sided 3M tape.
Step.3
Remove plastic backing film from the affixed two sided 3M tape. The plastic film can be remove easier
with the aid of a knife or cutting blade. Peel from leading edges and pull away from tape.
Step. 4
Position Hood Armor close to the hood and attach from the center of hood outward to the edges. Make
sure that it is evenly spaced before applying any pressure to armor
.
When satisfied with placement
apply pressure to all areas to properly secure armor to vehicle.
Pg.1
Step.5