Rugged Ridge Body Tub Rail, Body Armor, 97-06 Jeep Wrangler (TJ) - Manual

11650.40 - Body Tub Rail Armor (97-06 TJ Wrangler)
11650.41 - Body Tub Rail Armor (03-06 LJ Unlimited)
(97-06 TJ Wrangler with Bestop Supertop)
Tub Rail Protective Armor
1. Installation should be done when temperature is between 65° - 110° F (18°-43° C).
Clean mounting surface with rubbing alcohol. Avoid areas to which the product will not be adhered.
THIS MUST BE DONE FOR ADHESIVE TAPE TO PROPERLY STICK. FAILURE TO CLEAN
COULD RESULT IN POOR ATTACHMENT AND FAILURE OF PRODUCT TO STAY ATTACHED.
Allow areas to dry completely before attaching Body Tub Rail Covers.
Page 1 of 2 11650.4X 04-30-09
2. Test fit the Body Tub Rail Covers to the vehicle before removing the plastic backing film from the
double sided tape. This will aid in aligning the piece properly before securing. Peel back about an inch
of backing from each end of the double sided tape. The red protective plastic film can be removed
easier with the aid of a knife or cutting blade
.
3. Carefully position Body Tub Rail Cover onto tub. Peel tape backing from one end working slowly
to the opposite end. Make sure that both strips of the red protective film are being removed at the
same time. Press firmly along the entire top surface after cover has been installed.
11650.40 - (1) Left side rail cover with double-sided tape
Total length - 41.50"
(1) Right side rail cover with double-sided tape
Total length - 41.50" 11650.41 - (1) Left side rail cover with double-sided tape
Total length - 56"
(1) Right side rail cover with double-sided tape
Total length - 56"