Rugged Ridge 3-Inch Round Tube Side Steps, Titanium, 87-95 Jeep Wrangler (YJ) User Manual
Rugged Ridge For the car
Installation Instructions 1159X.03
Side Nerf Bars 1987 –1995 YJ Wrangler
Black, Black Textured, Titanium, Stainless
HARDWARE: Left and Right Side Bars
(16) 3/8” Self Tapping Bolts
Note: DRILLING WILL BE REQUIRED FOR
THE INSTALLATION OF THESE NERF BARS
IMPORTANT NOTICE: Carefully read all instructions
before installing this product. Rugged Ridge is not
responsible for any damage to vehicle or personal
injury that may occur during the installation of this
product.
To obtain correct installation, we recommend
that you follow the basic steps covered in
these instructions. Please Take care when
assembling this product to protect the finish
and to maintain a quality look to your new
investment. If able, have a second person to
assist with the installation.
PLEASE NOTE: The longer portion of the mounting bracket needs to be placed
towards the front of your vehicle.
STEP 1: Position the nerf bar up to the frame. Maintain a ½” minimum between the bottom of
the vehicle and the top of the nerf bar. Locate the nerf bar front to back so it is parallel with
the frame and the body. With the nerf bar in place (second person holding) mark the frame
through the nerf bar mounting holes located in the nerf bar bracket. After marks have been
made repeat for the other side and set the bars aside.