Rugged Ridge 2-Inch Receiver Hitch, 07-14 Jeep Wrangler (JK) - Manual

1
11580.10
Jeep® JK Wrangler Receiver Hitch
Contents:
1. Receiver Weldment (1)
2. Mounting Bolts (4)
3. Nylock Nuts (4)
4. Flat Washers (8)
Tow Rating: 2 DR JK (Up to 2000lbs)
4 DR JK (Up to 3500lbs)
DO NOT EXCEED THE MANUFACTURES STATED TOW
RATING FOR EACH MODEL. READ OWNERS MANUAL
BEFORE INSTALLING.
Caution - The Receiver Hitch installs very close to the muffler.
Ensure that the vehicle is cool before attempting install.
1. If your vehicle is equipped with a tow hook it must first be
removed from the vehicle. There are 3 bolts holding the
rear tow hook to the rear cross member. These must be
removed, and the tow hook slid down off the cross
member.
2. Slide the receiver over the rear crossmember, taking care
to align the 4 holes in the receiver with the 4 holes in the
cross member. Once in place, insert left or right most bolt
with flat washer into the back side of the hitch and
through the cross member. Place the nylock nut and flat
washer on to the bolt. Secure but do not tighten.