Rugged Ridge Tire Carrier, XHD Rear Bumper, 07-14 Jeep Wrangler (JK) - Manual

11546.22
Jeep
®
JK Wrangler XHD Rear Tire Carrier
Contents:
1. Frame (1)
2. Pivot Mount (1)
3. Latch Mount (1)
4. Lug Nuts (3)
5. Catch Pin (1)
6. M12 Washer (18)
7. M12 x 30 Hex Bolt (14)
8. Brake Light Mount (1)
9. Snap Ring (1)
10. Rub Strip (1)
11. Latch (1)
12. Bearing (2)
13. Spare Mount Plate (1)
14. M12 Lock Nut (7)
15. Spare Adjuster Plate (1)
16. Bearing Cap (1)
17. Castle Nut (1)
18. Cotter Pin (1)
19. Catch (1)
20. M6 Washer (12)
21. M6 x 20 Socket Cap Screw (2)
22. Ramp (1)
23. Brake Light Screw, Short (2)
24. Bumper Stop (2)
25. Ramp Shim (5)
26. Brake Light Screw, Long (2)
27. M6 x 20 Hex Bolt (10)
28. Safety Pin (1)
29. Wire Ties (8)*
30. Wire Loom (1)*
31. Rubber Plug (1)*
32. M16 Flat Washer (1)
1. If installing with a new XHD Rear Bumper, Install bumper brackets and place bumper on brackets,
but do not install D-Rings.
If installing on an existing XHD Rear Bumper, remove D-Rings. It may be necessary to loosen
brackets to help with hole alignment.
Remove spare tire and spare tire mount. Unplug third brake light wiring and set to the side.
Remove third brake light from spare tire mount.
Page 1 of 9
22
1
2
3
4
5
9
6
7
8
10
11
19
12
13
14
16
17
18
21
20
22
25
24
23
26
15
27
32
28
* Not Shown in Exploded View